DEM 6 + Sensor Tap
- Electronically controlled mini instantaneous water heater with 5.7 kW output
- Delivers a maximum of 50°C
- No standby or distribution losses
- Undersink installation
- Hardwired single phase connection
- Bundled with automatic sensor tap
If smaller volumes of warm water routinely are necessary, DEM is the ideal choice for the mini electronic instantaneous heater.
This device supplies water up to 50 ° C. The installation of the point of use overcomes long supply lines and losses of the line. There are also no common losses in water and energy resulting from manual adjustment of temperature. The DEM electronic is therefore ideally suited for washbasins where a constant temperature of the outlet is preferred.
The appliance is designed for undersink applications and hardwired to the 230 V mains.
|Model number||DEM 6|
|Rated output (230V)||5.7kW|
|Rated current (230V)||24.7Amp|
|Electrical Installation||As per AS/NZS3000|
|Installation requirements||AS/NZS3500.4.2 & local requirements|
|Switch on flow rate (minimum flow rate required to switch on the water heater)||2.2L/min|
|Permissible operating pressure||1000kPa|
|Temperature output||50°C max|
|For one/several draw off points||Yes/No|
|Heating system||Bare wire|
|Electronic flow rate control||No|
|Electronic air detection system||No|
|No downloads found for this product.|